venoplants.

Plant Propagation Hub

GGabijaUpdated 21 October 2026
First, the test

Take cuttings only from healthy stems that show active growth, keeping at least one node submerged or buried.

Plant propagation lets you grow new houseplants from stems, leaves, or root divisions of existing stock. The test for taking a cutting is simple: choose firm, disease-free stems with at least two leaves and one visible node, then place the node in clean water or moist substrate until new roots reach 3-5 cm.

01

Golden pothos

Epipremnum aureum

Golden pothos stems root reliably in plain tap water within two to three weeks when kept in bright indirect light. Cut 1 cm below a leaf node and strip the lowest leaf so only bare stem sits in water. Replace the water weekly to maintain oxygen levels around the emerging roots.

water propagationstem cuttings
  • +Roots within 14-21 days in water
  • +Visible root development reduces guesswork
  • −Water-grown roots must adapt after moving to soil
We do not sell this one
02

Heartleaf philodendron

Philodendron hederaceum

Heartleaf philodendron produces aerial root nubs along its vines that develop rapidly when submerged. Keep the cuttings at warm room temperatures between 18-24 °C (65-75 °F) to speed up root initiation. Once roots measure 5 cm, transplant the cutting into a light, well-draining potting mix.

water propagationeasy
  • +High success rate from single-node cuttings
  • +Tolerates average indoor humidity while rooting
  • −Can rot if submerged foliage is left on the stem
We do not sell this one
03

Spider plant

Chlorophytum comosum

Spider plants produce miniature plantlets on long runners that already possess root initials. You can pin these plantlets directly into moist soil while still attached to the parent, or snip them off and set their base in shallow water. Roots form within 10-14 days under moderate indoor light.

plantletsoffsets
  • +Plantlets often already have small root bumps
  • +Can root directly in potting soil or water
  • −Runners only form on mature specimens
We do not sell this one
04

ZZ plant

Zamioculcas zamiifolia

ZZ plants propagate from individual leaflets or entire stem bases placed into moist perlite or soil. The cutting slowly develops a small tuberous rhizome before sending up its first new shoot. Keep the substrate lightly moist rather than wet to avoid soft rot during the rooting period.

leaf cuttingsslow rooting
  • +Can propagate from a single detached leaflet
  • +Extremely drought tolerant once rooted
  • −Takes 3-9 months to produce new shoots
We do not sell this one
05

Snake plant

Dracaena trifasciata

Snake plant leaves can be cut into 5-8 cm sections and inserted right-side up into moist sand or perlite. Maintaining the original vertical orientation of each cutting is necessary, as inverted leaf sections fail to sprout. Divisions of the rhizome during repotting offer a much faster way to establish independent plants.

leaf cuttingsdivision
  • +One long leaf yields multiple cuttings
  • +Rhizome division produces instant mature plants
  • −Variegated cultivars lose yellow margins from leaf cuttings
We do not sell this one

What we left out

Fiddle leaf fig stem cuttings often rot in water without commercial bottom heat and high humidity tents. Mature woody stems take months to root and drop their large leaves indoors before establishing a root system.

Calathea and maranta stems cannot root from standard leaf cuttings because they lack traditional stem nodes. These prayer plants propagate through root division instead, which requires a mature root ball and risks severe transplant shock if divided too small, as detailed in our alocasia and calathea hub.

Succulents with fragile, thin stems frequently collapse from fungal damping-off if water propagation is attempted. They require several days of air-drying to callous over before resting on dry mineral grit under strong sun, which requires careful balance with room exposure, explained in our light hub.

Read next